1、打開鎖止環
1. Open locking ring
扭力扳手的手柄上方有一個鎖止環，需要將鎖止環下拉才可調節扭力。
There is a locking ring above the handle of the torque wrench, and the torque can be adjusted by pulling down the locking ring.
2、調節扭力
2. Adjusting torque
保持鎖止環下拉狀態，左右轉動手柄調節扭力，向右轉為扭力變大，向左轉為扭力減小。
Keep the locking ring in the pull-down state, turn the handle left and right to adjust the torque, turn right to increase the torque, and turn left to decrease the torque.
3、讀取刻度
3. Read scale
持續轉動手柄，轉動目標扭力時停止。桿上的數字為主刻度，手柄上方轉動位置的刻度為副刻度，讀數為主刻度與副刻度相加。
Keep turning the handle until it reaches the target torque. The number on the lever is the main scale, the scale at the rotating position above the handle is the sub scale, and the reading is the addition of the main scale and the sub scale.
4、關閉鎖止環
4. Close the locking ring
扭力調整完成后，將鎖止環向上推鎖定刻度調節功能，左右旋轉手柄確保鎖止到位，即可使用。
After the torque adjustment is completed, push the locking ring upward to lock the scale adjustment function, and rotate the handle left and right to ensure that it is locked in place.
The above is the detailed introduction of the torsion shear wrench manufacturer. I hope it will help you. If you have any questions, please contact us. We will provide you with services with a professional attitude http://www.ykmzc.com
