電動扳手與套筒連接的方式有三種，每種方式在使用中都有各自的注意事項，下面電動扳手廠家來詳細介紹下。
There are three ways to connect electric wrench with sleeve. Each way has its own precautions in use. The following electric wrench manufacturer will introduce in detail.
扳手與套筒連接種方式是卡環方式，注意事項:
The first way to connect the wrench with the sleeve is the clasp way.
a.本方法僅適用于M16以下螺絲。
A. This method is only applicable to the screw below M16.
b.保持彈簧外的余度在0.8mm以上。
B. Keep the surplus outside the spring above 0.8 mm.
電動扳手彈簧球方式注意兩點：
Two points should be paid attention to in the spring ball mode of electric wrench:
a.本方法僅適用于M16以下螺絲。
A. This method is only applicable to the screw below M16.
b.在連接前確認上圖中彈簧球的動作。
B. Verify the action of the spring ball in the picture above before connecting.
扭剪扳手:電動扳手與套筒連接的三種方式
Torsion wrench: three ways of connecting electric wrench with sleeve
扳手與套筒連接第三種方式就是橡皮銷固定方式，注意三點：
The third way to connect the wrench to the sleeve is to fix the rubber pin. Pay attention to three points:
a.使用前應當確認橡皮套沒有開裂、彈性減少等老化。
A. Before use, it should be confirmed that the rubber sleeve does not crack, and the elasticity decreases.
b.銷子的外徑尺寸是孔徑-0.5mm。
B. The outer diameter of the pin is - 0.5mm.
c.銷子、橡皮壓緊件應當使用正規的產品，不得使用自己制作的或者現有的。
C. Pins and rubber pressing parts shall be made of regular products and shall not be made by themselves or existing ones.
以上
扭剪扳手廠家給大家詳細介紹了扳手與套筒的三種連接方式，希望可以幫大家加深了解http://www.ykmzc.com。
The above wrench manufacturer has introduced three connection ways between wrench and sleeve in detail, hoping to help you understand more about http://www.ykmzc.com.
